Roller plate bending machine

A roller plate bending machine is a device that uses work rolls to bend metal plates,which can form cylindrical parts,conical parts,and other parts of different shapes.It is a very important processing equipment.A plate roller plate bending machine refers to the use of external forces such as hydraulic and mechanical forces to move the work roll,thereby bending or rolling the plate.What is the solution for the roller plate bending machine not turning?
1、Check the power supply and wiring

Firstly,it is necessary to check whether the power supply and wiring of the bending machine are normal.Ensure that the power plug is securely connected and the circuit is not damaged or aged.At the same time,check if the power supply voltage is stable and within the specified range.If any problems are found,they should be repaired or replaced in a timely manner.

2、Adjust the load and rollers
Excessive load on the roller plate bending machine may also cause it to not rotate.At this point,it is necessary to check if the rollers are too tight or if the gears are damaged.Adjust the tightness of the rollers and elastic wheels appropriately to reduce the load and enable the plate roller plate bending machine to rotate normally.
3、Replace bearings and drive belts
Bearings are one of the key components of the plate roller plate bending machine.If the bearings rust or are damaged,it may also cause the plate roller plate bending machine to not rotate.Therefore,it is necessary to regularly check the condition of the bearings and replace them in a timely manner if there are any abnormalities.At the same time,excessive or insufficient tension in the drive belt may also cause problems.It is necessary to check the condition of the drive belt to prevent aging or damage,and replace it with a new one in a timely manner.
4、Other precautions
When dealing with the problem of the roller plate bending machine not turning,the following points should also be noted:
Ensure proper operation procedures to avoid equipment malfunctions caused by misoperation.
Regularly maintain and upkeep the equipment to extend its service life.
If the problem persists or cannot be resolved,professional maintenance personnel should be contacted in a timely manner for inspection and repair.
In summary,dealing with the problem of the roller plate bending machine not rotating requires starting from multiple aspects,including checking the power supply and wiring,adjusting the load and rollers,replacing bearings and drive belts,etc.At the same time,attention should also be paid to operating standards and regular maintenance and upkeep of equipment.